悬浮无轨平移门制作方法大概如下——
The manufacturing method for floating trackless sliding doors is roughly as follows——
1、防护机构连接固定在上梁和底梁之间；
1. The protective mechanism is connected and fixed between the upper beam and the bottom beam;
2、与防护机构位置对应的矩形贯穿槽设在机箱的里面；
2. The rectangular through groove corresponding to the position of the protective mechanism is located inside the chassis;
3、下传动齿条连接固定在底梁的下端；
3. The lower transmission rack is connected and fixed at the lower end of the bottom beam;
4、上传动齿条连接固定在上梁的上端侧壁；
4. Connect and fix the upper end sidewall of the upper beam with the upper moving gear rack;
5、与下传动齿条相啮合的传动机构安装在机箱的下端里面；
5. The transmission mechanism that meshes with the lower transmission rack is installed inside the lower end of the chassis;
6、与上传动齿条相互啮合的辅助移动机构安装在机箱的上端里面；
6. An auxiliary moving mechanism that meshes with the upper gear rack is installed inside the upper end of the chassis;
7、门排后拉杆倾斜设置固定连接在底梁长度大于上梁长度的底梁与上梁靠近机箱的一头之间；
7. The inclined rear pull rod of the door truss is fixedly connected between the bottom beam with a length greater than the upper beam and one end of the upper beam near the chassis;
8、保护机构连接固定在底梁与上梁远离机箱的一端之间；
8. The protection mechanism is connected and fixed between the bottom beam and the end of the upper beam away from the chassis;
9、导向机构设在保护机构与机箱之间；
9. The guiding mechanism is located between the protection mechanism and the chassis;